Probe V6-182 3.0L (1990)
NOTE: Be careful not to confuse lower ball joint looseness with bearing looseness.
If abnormal looseness or noise is found, disassemble the hub and knuckle, inspect the bearings, and adjust the bearing preload.
4. Remove the wheel and remove the disc brake caliper. Hang the caliper from the coil spring using a cord or piece of wire.
Checking End Play With Dial Indicator.
5. Position a Dial Indicator Tool-4201-C against the wheel hub, then push and pull the wheel hub. Measure the end play of the wheel hub and bearing
assembly. If the end play exceeds the specified limit, replace the bearings.
