Probe V6-182 3.0L (1990)
Figure 21
7.
Measure the inboard distance of the glass at points A, B and C, Figure 21. The measurement at point A should be 23.5 mm +/- 1.5 mm. The
measurement at point B should be 19.5 mm +/- 1.5 mm. The measurement at point C should be 24.0 mm +/- 1.5 mm.
8.
If inboard or outboard door glass adjustment is necessary, locate the Phillips slotted stud that holds the door glass regulator.
9.
Loosen the lock nut on the Phillips slotted stud and turn the screw to adjust the door glass to the specification in Step 7.
10.
Reinstall the interior door trim panel.
11.
Reinstall the door glass seal in the roof retainer.
12.
If the windnoise or water leak concerns are still present or the proper adjustment cannot be reached, proceed to the weather seal retainer
modification.
Weather Seal Retainer Modification and Inspection
WEATHER SEAL RETAINER MODIFICATION
1.
Remove the weather seal form the roof retainer.
2.
Remove the roof retainer from the car.
3.
Starting at the front of the roof retainer, enlarge the first three (3) attaching screw holes from 5 mm to 7 mm.
4.
Re-position the roof retainer. Use flat washers on the enlarged holes.
5.
Before tightening the roof retainer attaching screws, pull the roof retainer outward and then secure the attaching screws.
6.
Reinstall the weather seal to the roof retainer.
7.
If windnoise or water leak concerns are still present, proceed to the door opening body weatherstrip inspection.
DOOR OPENING UPPER BODY WEATHERSTRIP INSPECTION
Check for proper air and water sealing of the door glass to the upper door opening body weatherstrip.
PART NUMBER
PART NAME
CLASS
E92Z-6102316-A
Push Pin Button
B
GJ21-50-H81
Fastener
C
