Probe V6-182 3.0L (1990)
Figure 1
NOTE:
THE SLIDER CENTER BRACKET AND LOWER GUIDE PLATE, FIGURE 1, MUST BE WIPED CLEAN BEFORE
INSTALLING THE FOAM INSULATORS.
6.
Determine the location for the upper foam insulator, Figure 1.
a.
Position the foam insulator between the regulator channel and the center bracket, almost resting on the roller wheel.
b.
Carefully remove the paper backing from the foam insulator and press it into place.
7.
Use a suitable tool to fold the top of the foam insulator down between the glass and the bracket.
8.
Remove the two (2) bolts holding the lower guide plate. Pull the guide plate down to make installation of the lower foam
insulator easier.
9.
Install the foam insulator onto the guide plate as shown in Figure 1. Fold the bottom of the insulator up around the guide plate.
10.
Position the slider bracket.
a.
Install the lower guide plate bolts, but do not tighten.
b.
Slide the guide plate forward, toward the front of the door.
c.
Tighten the two (2) bolts.
11.
Make sure the rattle has been eliminated by repeating Step # 1.
12.
Raise and lower the glass several times to be sure the foam insulators do not contact or rub the roller, cable or channel.
13.
Check the glass for proper positioning.
a.
Raise the glass to the closed position.
b.
Close the door several times to check for proper positioning of the glass to the weatherstrip and blow out clip.
c.
Adjust as needed.
14.
Install the door water shield and door panel.
OTHER APPLICABLE ARTICLES: None
SUPERSEDES:
90-2-2
WARRANTY STATUS:
Eligible Under Basic Warranty Coverage
OPERATION
DESCRIPTION
TIME
910102AT
Install Insulator - Both
1.3 Hr.
