ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Parking Brake Cable > < Parking Brake Cable Adjustment

Ranger 2006.5 (05.2006-)

Parking Brake and Actuation - Parking Brake Control Ranger 2006.5 (05/2006-)
Removal and Installation

  1. Remove the lower panel.
    For additional information, refer to: Instrument Panel Lower Trim Panel (501-12 Instrument Panel and Console, Removal and Installation).

2. Remove the components in the order indicated in the following illustration(s) and table(s).

 
Item
Part Number
Description
1
-
Parking brake switch connector
2
-
Clip
3
-
Front parking brake cable
See Removal Detail
See Installation Detail
4
-
Bolt and nut
5
-
Parking brake lever component
6
-
Parking brake switch
7
-
Clip and joint pin
8
-
Cable connector
9
-
Clip and joint pin
10
-
Clip and joint pin
11
-
Lever
12
-
Clip and joint pin
13
-
Spring
14
-
Ratchet pawl
15
-
Stopper
16
-
Fork joint
17
-
Spring
18
-
Guide
19
-
Rod

3. To install, reverse the removal procedure.

  1. After installation, inspect the parking brake lever stroke.
    For additional information, refer to: Parking Brake Cable Adjustment (206-05 Parking Brake and Actuation, General Procedures).

Removal Details

Item 3 : Front parking brake cable
  1. Slide the clip installed to the cable connector in the direction shown by the arrow.

  1. Remove the end of the front parking brake cable from the cable connector.

Installation Details

Item 3 : Front parking brake cable
  1. Install the front parking brake cable with the spring installation area of the equalizer pointed towards the inside of the vehicle.

  1. Install the front parking brake cable with the spring installation area of the equalizer pointed towards the inside of the vehicle.

Parking Brake Cable > < Parking Brake Cable Adjustment