ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Crankshaft Position (CKP) Sensor > < Electronic Engine Controls
Electronic Engine Controls - Camshaft Position (CMP) Sensor Ranger 2006.5 (05/2006-)
Removal and Installation

Removal

CAUTION:
CAUTION:When replacing the CKP sensor, make sure there is no foreign material on it such as metal shavings. If it is installed with foreign material, the sensor output signal will malfunction resulting from fluctuation in magnetic flux and cause a deterioration in engine control.
  1. Disconnect the negative battery cable.

  1. Remove the CMP sensor.

Installation

  1. Install in the reverse order of removal.
    • CMP sensor tightening torque 7.8—10.8 Nm {80—110 kgf·cm, 70—95 in·lbf}.

Crankshaft Position (CKP) Sensor > < Electronic Engine Controls