ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
309 Exhaust System > < Transfer Case

Ranger 2006.5 (05.2006-)

Transfer Case - Vehicles With: Automatic Transmission - Rear Output Shaft Speed (OSS) Sensor Ranger 2006.5 (05/2006-)
In-vehicle Repair

Removal and Installation

CAUTION:
CAUTION:Water or foreign material entering the connector can cause poor connections or corrosion. Be sure that water or foreign material do not enter the connector when disconnecting it.
CAUTION:
CAUTION:Do not damage the speed sensor.
  1. Disconnect the negative battery cable.
  1. Remove the transfer case under cover.
    For additional information, refer to: Transaxle (307-01 Automatic Transmission/Transaxle, Removal).

  1. Remove in the order indicated in the table.
    1 Connector (wiring harness-side)
    2 Connector (part side)
    3 Connector cover
    4 Clutch coil terminal
    5 Speed sensor bracket
    6 Wiring harness bracket
    7 Speed sensor
  1. Install in the reverse order of removal.

309 Exhaust System > < Transfer Case