ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
In-vehicle Repair > < Transfer Case

Ranger 2006.5 (05.2006-)

Transfer Case - Vehicles With: Automatic Transmission - Transfer Case Draining and Filling Ranger 2006.5 (05/2006-)
General Procedures

Materials
Name
Specification
Transmission Fluid
MERCON® V 
  1. Warm up the transfer case.
  1. Remove the transfer case under cover.
    For additional information, refer to: Transaxle (307-01 Automatic Transmission/Transaxle, Removal).

  1. CAUTION:
    CAUTION:Do not use an impact wrench when removing the filler plug or drain plug. It may damage the transfer case.
    Remove the drain plug from the transfer case.
  1. Drain the oil into a suitable container.
  1. Tighten the new drain plug.
    • Tightening torque 19—30 N·m {2.0—3.0 kgf·m, 15—22 ft·lbf}
  1. Remove the filler plug and add the specified amount and type of oil through the filler plug hole until the level reaches the bottom of the filler plug hole.
  1. Tighten the new filler plug.
    • Tightening torque 19—30 N·m {2.0—3.0 kgf·m, 15—22 ft·lbf}
  1. Install the transfer case under cover.
    For additional information, refer to: Transaxle (307-01 Automatic Transmission/Transaxle, Installation).

In-vehicle Repair > < Transfer Case