| Removal and Installation Removal | | -
Disconnect the negative battery cable (with power window system).
For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
| | | -
Open the cap using a small flathead screwdriver and remove the screw. | | -
Remove the inner handle cover. | | | -
Remove the regulator handle, if equipped.
For additional information, refer to: Door Window Regulator Handle (501-11 Glass, Frames and Mechanisms, Removal and Installation).
| | | -
Remove tabs A using a fastener remover and then remove the weatherstrip by pulling it upward. | | | -
Detach clips A from the front door using a fastener remover. | | | -
Pull the rear door trim in the direction of the arrow and remove pin C and tabs B. | | | -
Disconnect the power window subswitch connector, if equipped. | | | -
Remove the rear door trim. | Installation | | -
Install in the reverse order of removal. | | |
