ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Heated Window Grid Wire Repair > < Glass, Frames and Mechanisms

Ranger 2006.5 (05.2006-)

Glass, Frames and Mechanisms - Door Window Motor Initialization Ranger 2006.5 (05/2006-)
General Procedures

NOTE:
NOTE:Initial setting must be performed for the switch of each window.
NOTE:
NOTE:If the following operations have been performed; initial setting is reset, and auto up/down are disabled, negative battery cable disconnected or power window system power supply fuse removed (perform initial setting for the switches of all windows), power window switch connector disconnected (Perform initial setting for the switch connected with the connector), prolonged open/close operation of the power window main or sub switches causes the circuit breaker to activate and automatic operation is disabled. Then, door window motor initialization is required.
  1. Turn the ignition switch to the ON position.
  1. Press the switch of each window and fully open the door glass.
  1. Pull the switch of each window to the manual-up position to fully close the door glass, and keep holding the switch up at the position for approx 2 s.

Heated Window Grid Wire Repair > < Glass, Frames and Mechanisms