Ranger 2WD L4-140 2.3L SOHC (1984)
Adjustment Lever Assembly
5. Pull the adjusting lever, cable and automatic adjuster spring down and toward the rear to unhook the pivot hook from the large hole in the
secondary shoe web.
CAUTION: Do not pry the pivot hook out of the hole.
6. Remove the automatic adjuster spring and adjusting lever.
NOTICE: Note the color and position of each spring, they must be re-assembled in same position.
Removing/Installing Brake Springs
7. Remove the secondary shoe-to-anchor spring using a suitable brake spring removal / installation tool. Using the same tool, remove the primary
shoe-to-anchor spring and unhook the cable anchor. Remove the anchor pin plate (if equipped).
NOTE: For additional information see Brake Spring Removal and Installation Notes.
8. Remove the cable guide from the secondary shoe.
Removing/Installing Shoe Hold Down Springs
9. Remove the shoe hold-down springs using a hold down spring tool. Remove the shoes, adjusting screw, pivot nut, and socket.
10. Remove the parking brake link and spring. Disconnect the parking brake cable from the parking brake lever.
