Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
Keyless Entry Transmitter: Service and Repair
NOTE
^
All keyless entry remote transmitters are programmable and must be set at the same time.
^
To program (or reprogram) the keyless entry remote transmitters into the RAP module, perform the following steps:
1. Make sure that the anti-theft system is not armed or triggered.
2. Turn the ignition switch from OFF to RUN eight times within ten seconds, ending in RUN. If the RAP module has successfully entered program
mode, it will lock and then unlock all doors.
3. Within 20 seconds, press any button on a keyless entry remote transmitter, and the doors will lock and then unlock to confirm that each transmitter
has been programmed. Repeat for each transmitter
4. If the door locks do not respond for any keyless entry remote transmitter, wait several seconds and press the button again. If the door locks still fail
to respond, refer back to the pinpoint test.
5. Turn the ignition switch to the OFF position, or wait up to 20 seconds after step 2, to exit program mode. If a keyless entry remote transmitter has
been programmed (or reprogrammed), the RAP module will lock and unlock all doors one last time to confirm.
