Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
5. Install the parking brake strut.
1
Install the parking brake link spring and the parking brake spring retainer on the parking brake strut.
2
Install the parking brake strut.
3
Install the brake shoe anchor pin guide plate.
6. Install the short brake shoe retracting spring.
1
Place the brake shoe adjusting lever cable over the anchor pin, with crimped side in.
2
Install the short brake shoe retracting spring.
7. Install the long brake shoe retracting spring.
1
Install the cable guide.
2
Position the brake shoe adjusting lever cable in the cable guide groove.
3
Install the long brake shoe retracting spring.
NOTE: Make sure the brake shoe adjusting lever cable is positioned in the cable guide groove.
8. Assemble the brake adjuster screw assembly.
1
Apply Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A (Motorcraft WA-10) or an equivalent silicone compound
meeting Ford specification ESE-M1C171-A.
2
Install the brake adjuster screw into the brake shoe adjusting screw nut to the end of the threads, and then loosen one-half turn.
3
Install the brake shoe adjusting screw socket on the brake shoe adjusting screw nut.
NOTE: To prevent incorrect installation, the socket end of each brake adjuster screw is stamped R or L.
