Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
pedal action. This requires bleeding of the hydraulic system after it has been properly connected. The hydraulic system can be bled manually
or with pressure bleeding equipment.
-
When the brake master cylinder has been replaced or the system has been emptied or partially emptied, it must be primed to prevent air from
entering the system.
1. For in-vehicle priming, disconnect the brake lines from the brake master cylinder.
2. For bench priming, mount the brake master cylinder in a vise.
3. Install short brake tubes with the ends bent into the brake master cylinder reservoir.
-
Fill the brake master cylinder reservoir with High Performance DOT 3 Brake Fluid C6AZ-19542-AB or DOT 3 equivalent meeting Ford
specification ESA-M6C25-A.
4. For a new brake master cylinder, remove the cruise switch.
