Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Solenoid Valve Body
REMOVAL
WARNING: BRAKE FLUID CONTAINS POLYGLYCOL ETHERS AND POLYGLYCOLS. AVOID CONTACT WITH EYES. WASH
HANDS THOROUGHLY AFTER HANDLING. IF BRAKE FLUID CONTACTS EYES, FLUSH EYES WITH RUNNING WATER FOR 15
MINUTES. GET MEDICAL ATTENTION IF IRRITATION PERSISTS. IF TAKEN INTERNALLY, DRINK WATER AND INDUCE
VOMITING. GET MEDICAL ATTENTION IMMEDIATELY.
CAUTION:
-
Do not allow the brake master cylinder reservoir to run dry during the bleeding operation. Keep the brake master cylinder reservoir filled
with the specified brake fluid. Never reuse the brake fluid that has been drained from the hydraulic system.
-
Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
1. Disconnect the RABS valve electrical connector.
2. Remove the two hydraulic lines and plug them.
3. Remove the bolts and remove the RABS valve and bracket assembly.
INSTALLATION
