Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
Brake Light Switch: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
2. Disconnect the Brake Pedal Position (BPP) switch connector.
3. Remove the BPP switch.
1
Remove the self locking pin.
2
Remove the spacer.
3
Remove the BPP switch.
INSTALLATION
1. To install, reverse the removal procedures.
NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive
strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.