Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
Alignment: Service and Repair
Caster and Camber
1. Remove the nuts and alignment plates.
2. Install the cams and the nuts.
3. To increase caster and camber, use the following steps.
(1) To increase caster, move the front of the front suspension arm bushing joint outboard and move the rear of the front suspension arm bushing
joint inboard.
(2) To increase camber, move the front suspension arm bushing joint outboard equally.
NOTE:
-
A pry bar can be used between the front suspension arm bushing joint and the frame pocket to aid in moving the arm.
-
When adjusting the RF camber/caster, adjustment at the RF lower control arm adjustment cam is not recommended.
