Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
11. Remove the crankshaft position sensor.
INSTALLATION
1. Install the crankshaft position sensor.
NOTE: The engine front cover design precisely locates the crankshaft position sensor so that an adjustment is not required.
2. Connect the crankshaft position sensor.
3. Install a new O-ring on the water pump inlet tube.
4. Install the water pump inlet tube into the water pump.
5. Install the water pump inlet tube to the generator.
6. Install the heater water hose on the water pump inlet tube.
7. Position the generator and install three bolts.
8. Install the drive belt.
9. Connect the battery ground cable.
