Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
Parts Replacement Chart
1. Remove the broken or stripped bolt and discard.
2. Drill out the internal threads in the safety belt anchor plate with a 27/64 inch drill bit.
3. Rethread the anchor plate with a 1/2-13 tap (seat belt).
4. Install the attachment parts. Original parts are to be replaced with the repair parts indicated in the manufacturer's safety belt replacement guidelines
indicated by the parts replacement chart. Unless otherwise specified, use original parts.
Seat Belt Without Anchor Plate Thread Damage
1. Expose the suspect anchor point.
NOTE: If the B-pillar safety belt anchor nuts or reinforcements are stripped or missing, they should be replaced with a new nut/reinforcement
plate.
2. Drill out two 8 mm (5/16 in) diameter access holes adjacent to the weld nut clearance hole.
3. Thread a length of copper welding wire through the clearance hole and position to secure the weld nut and washer.
4. Use MIG Wire Feed Welder and plug weld a 7/16 inch weld nut and standard washer in place at the two 8 mm (5/16 in) holes.
5. Metal finish as required.
6. Install the restraint system.
7. Perform the functional test. See: Testing and Inspection/Component Tests and General Diagnostics
