Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor
Rear Antilock Brake System
REMOVAL
1. Raise and support the vehicle.
2. Remove the rear anti-lock brake sensor.
1
Disconnect the rear anti-lock brake sensor electrical connector.
2
Remove the bolt.
3
Remove the rear anti-lock brake sensor.
CAUTION: Before removing the rear anti-lock brake sensor, clean any dirt around the sensor to prevent the dirt from contaminating the rear axle
fluid.
INSTALLATION
1. Clean and inspect the rear anti-lock brake sensor.
1
Clean the axle mounting surface.
2
Inspect and clean the magnetized rear anti-lock brake sensor pole piece.
3
Inspect the rear anti-lock brake sensor for damage; replace if necessary.
4
Lightly lubricate the rear anti-lock brake sensor 0-ring with motor oil.
CAUTION: Do not get dirt in the rear axle housing.
