Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
Torque Converter Clutch Solenoid: Service and Repair
Replacement
REMOVAL
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. Remove fluid pan and gasket.
4. Remove the transmission fluid filter.
1. Remove the screw.
2. Remove the transmission fluid filter.
5. Remove wire loom guide and protector.
-
Carefully lift up on wire loom guide and protector and disengage the retaining pins from the solenoid clamps.
NOTE: Main control assembly does not need to be removed for solenoid service.
6. Disconnect the appropriate solenoid electrical connector.
1. Disconnect shift solenoids electrical connectors.
2. Disconnect the Torque Converter Clutch (TCC) solenoid electrical connector.
3. Disconnect the Electronic Pressure Control (EPC) solenoid electrical connector.