Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
11. Remove the transmission case (16 pin) electrical connector.
-
Compress the tabs on the transmission case (16 pin) electrical connector.
-
Push the transmission case (16 pin) electrical connector out of transmission case.
CAUTION: Do not damage the connector or harness.
INSTALLATION
1. Install the transmission case (16 pin) electrical connector.
-
Lubricate the transmission case (16 pin) electrical connector O-rings with petroleum jelly.
NOTE:
-
Make sure the tab is in the lock position.
-
Install new O-rings on the transmission case (16 pin) electrical connector.
2. Press the transmission case (16 pin) electrical connector through the case until a click is heard.
3. Install the TSS sensor wire.
1. Install TSS sensor wire into (16 pin) case connector.
2. Install TSS sensor wire into the locator.
CAUTION: Align the slot on the Turbine Shaft Speed (TSS) sensor electrical connector with the slot in the 16 pin case connector.
