Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
Band Apply Servo: Service and Repair
Low/Reverse Servo Assembly - Replacement
Special Tools
REMOVAL
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. Remove the transmission pan.
4. Remove the transmission fluid filter.
1. Remove the screw.
2. Remove the transmission fluid filter.
5. Remove the low/reverse band servo cover.
1. Remove the low/reverse servo cover screws.
2. Remove the low/reverse band servo cover and gasket. Discard the low/reverse servo separator plate cover gasket.
