Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
5. Install Dial Indicator with Bracketry on the transmission case.
1. Position the indicator on the piston pad.
2. Set the dial indicator to zero.
6. Back out the servo gauge adjusting screw until it bottoms out on the tool. Record the distance the servo piston traveled.
NOTE: If the piston travel in this step is 3-5.6mm (0.120-0.220 inch), it is within specification. If the piston travel is greater than 5.6mm (0.220
inch), use the next longer piston and rod. If the piston travel is less than 3mm (0.120 inch), use the next shorter piston and rod.
7. Use the above procedure to check the piston travel with the newly selected low/reverse band servo piston and rod (if required) to make sure that
the piston travel is 3-5.6mm (0.120-0.220 inch). Remove the servo gauge and the low/reverse band servo return spring.
-
Grooves are located on low/reverse servo rod.
CAUTION: Make sure the test spring is removed after this step.
