Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
NOTE: If the steel plates are being replaced, make sure to use the correct steel plates. SOHC use 1.71 mm steel plates (5 req'd). EI use 2.14 mm
steel plates (4 req'd).
12. Install the direct clutch pressure plate.
1. Install the direct clutch pressure plate.
2. Install the original direct clutch retaining ring on the direct clutch disc pack.
CAUTION: The retaining ring is a select fit.
13. Check the operation using compressed air.
WARNING: AIR PRESSURE MUST NOT EXCEED 138 KPA (20 PSI). WEAR SAFETY GLASSES WHEN USING COMPRESSED
AIR. MAKE SURE THE DRUM IS FACING DOWN AS SHOWN.
NOTE: The direct clutch piston must apply with air pressure and release when the air is removed.
-
Apply air pressure to the hole in the drum while blocking the other hole with a finger.
14. Push down on direct clutch disc pack and check gap between the direct clutch retaining ring and the direct clutch pressure plate with a feeler
gauge.
