Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
Part 3 Of 3 - Overdrive Brake and Coast Clutch Drum Assembly
DISASSEMBLY
1. Remove the coast clutch pressure plate.
1. Remove the coast clutch retaining ring.
2. Remove the coast clutch pressure plate.
CAUTION:
-
If new plates are being used, they should be soaked in clean transmission fluid for at least 30 minutes before assembly.
-
This is a select fit ring. See assembly procedure if the ring or clutch plate is replaced.
2. Remove the coast clutch disc pack.
-
Inspect for wear, replace as necessary.
CAUTION:
-
If new clutch plates are being used, they should be soaked in clean transmission fluid for at least 30 minutes before assembly.
-
Coast clutch friction plates are directional. Note direction of grooves for installation.