Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
3. Remove the coast clutch piston retaining ring.
1. Use Clutch Spring Compressor to compress the coast clutch piston springs.
2. Remove the coast clutch piston retaining ring.
WARNING: USE CAUTION WHEN RELEASING TOOL PRESSURE ON THE REAR CLUTCH PISTON SPRING.
CAUTION: Do not fully compress the Clutch Spring Compressor or damage to the spring retainer may occur.
4. Relieve the direct clutch spring tension and remove the Clutch Spring Compressor.
5. Remove the coast clutch piston springs.
1. Remove the coast clutch piston spring retainer.
2. Remove the (20) clutch piston springs.
6. Remove the coast clutch piston.
-
Apply air pressure to the hole in the drum to remove coast clutch piston while blocking other hole with finger.
WARNING: AIR PRESSURE MUST NOT EXCEED 138KPA (20 PSI). WEAR SAFETY GLASSES WHEN USING COMPRESSED
AIR, AND MAKE SURE DRUM IS FACING DOWN AS SHOWN.
7. Remove the coast clutch piston inner seal and the coast clutch piston outer seal.
-
Clean and replace as necessary.
