Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
10. When installing friction plates, the word (TOP) should face up. If reusing plates, grooves must be installed clockwise. Install the direct clutch disc
pack.
CAUTION:
-
The direct clutch friction plates are directional and must be installed with grooves pointing clockwise (I.D. to O.D.) and the word (TOP)
facing up.
-
If new plates are used, they should be soaked in clean transmission fluid for at least 30 minutes before assembly.
11. Install the steel clutch plates and friction clutch plates in alternating order starting with a steel clutch plate.
NOTE: If the steel plates are being replaced, make sure to use the correct steel plates. SOHC use 1.71 mm steel plates (5 req'd). EI use 2.14 mm
steel plates (4 req'd).
12. Install the direct clutch pressure plate.
1. Install the direct clutch pressure plate.
2. Install the original direct clutch retaining ring on the direct clutch disc pack.
