Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
-
This is a select fit ring. See assembly procedure if the ring or clutch plate is replaced.
2. Remove the coast clutch disc pack.
-
Inspect for wear, replace as necessary.
CAUTION:
-
If new clutch plates are being used, they should be soaked in clean transmission fluid for at least 30 minutes before assembly.
-
Coast clutch friction plates are directional. Note direction of grooves for installation.
3. Remove the coast clutch piston retaining ring.
1. Use Clutch Spring Compressor to compress the coast clutch piston springs.
2. Remove the coast clutch piston retaining ring.
WARNING: USE CAUTION WHEN RELEASING TOOL PRESSURE ON THE REAR CLUTCH PISTON SPRING.
CAUTION: Do not fully compress the Clutch Spring Compressor or damage to the spring retainer may occur.
4. Relieve the direct clutch spring tension and remove the Clutch Spring Compressor.
5. Remove the coast clutch piston springs.
1. Remove the coast clutch piston spring retainer.
2. Remove the (20) clutch piston springs.
