Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
5. Install the extension housing.
1. Position the extension housing.
2. Install the screws.
3. Install the extension housing stud.
6. If equipped, install the transfer case.
CAUTION: Make sure the parking lever actuating rod is correctly seated into the case parking rod guide cup.
7. Install the bolts.
NOTE: Align the drive shaft with the marks made during removal to ensure correct balance.
8. Install the transmission case (16 pin) electrical connector.
-
Lubricate the transmission case (16 pin) electrical connector O-rings with petroleum jelly.
NOTE:
-
Make sure the tab is in the lock position.
-
Install new O-rings on the transmission case (16 pin) electrical connector.
9. Press the transmission case (16 pin) electrical connector through the case until a click is heard.
