Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
Selector Shaft: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. Remove the transmission fluid pan.
NOTE: It is not necessary to remove the transmission fluid filter to perform this procedure.
4. Remove the digital Transmission Range (TR) sensor;.
5. Remove the manual control valve detent lever spring.
1. Remove the screw.
2. Remove the manual control valve detent lever spring.
6. Remove the nut.
CAUTION: Do not damage the valve inner lever pin.
