Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
8. Using a soft-faced hammer, drive the pinion assembly out of the outer pinion bearing, and remove the drive pinion through the rear of the housing.
9. Remove the collapsible spacer and discard it.
10. Use the Bearing Pulling Attachment to remove the inner pinion bearing.
11. If the pinion bearing cups are to be replaced, tap alternately (with a brass drift of suitable length) on opposite sides of the cup during removal to
prevent cup from cocking in the casting.
NOTE: Do not remove the pinion bearing cups from the carrier casting unless the cups are damaged.
INSTALLATION
