Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
1. Drive the outer pinion bearing cup into the axle housing using Pinion Bearing Cup Replacer and Driver Handle.
2. Drive the inner pinion bearing cup into the axle housing using Pinion Bearing Cup Replacer and Driver Handle.
3. Make sure the cups are properly seated in their bores.
CAUTION: Whenever the cups are replaced, the pinion bearings must also be replaced.
NOTE: If a feeler gauge can be inserted between a cup and the bottom of its bore at any point around the cup, the cup is not properly seated.
4. Make sure the cups are properly seated in their bores.
1. Position the Screw.
2. Position the Aligning Adapter.
3. Position the Gauge Disc.
4. Position the Gauge Block.
5. Position the inner pinion bearing.
6. Position the outer pinion bearing.
7. Thread on the Driver Handle.
NOTE: Apply only a light oil film on the pinion bearings before assembling the tool.
