Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
3. Install the driveshaft slip yoke.
1. Lubricate the stub shaft splines, and pull the driveshaft slip yoke boot towards the driveshaft.
-
Use Premium Long-Life Grease XG-1-C or -K or equivalent meeting Ford specification ESA-MIC75-13.
2. Fill the driveshaft slip yoke boot with approximately 10 grams of lubricant.
-
Use Premium Long-Life Grease XG-1-C or -K or equivalent meeting Ford specification ESA-MIC75-13.
3. Position the large driveshaft slip yoke boot clamp.
4. Align the blind splines, and install the driveshaft slip yoke.
4. Install the large driveshaft slip yoke boot clamp.
1. Remove any excess grease from the differential slip yoke boot and driveshaft slip yoke surfaces.
2. Position the driveshaft slip yoke boot over the driveshaft slip yoke boot groove.
3. Position the driveshaft slip yoke to specification from the driveshaft weld to the end of the slip yoke splines.
4. Bleed air from the driveshaft slip yoke boot.
5. Use Keystone Clamp Pliers to crimp the large driveshaft slip yoke boot clamp.
5. Install the driveshaft.
