Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
2. Install the driveshaft flange yoke.
1. Start a new bearing cup into the driveshaft flange yoke.
2. Position the driveshaft flange yoke.
3. Position the driveshaft in the U-Joint Tool.
4. Press the bearing cup below the yoke surface.
-
Repeat for the other bearing cup.
3. Remove the driveshaft from the U-Joint Tool, and install the four snap rings.
NOTE: Use the yellow snap rings supplied in the kit to assemble the universal joint (U-Joint). If difficulty is encountered with the yellow snap
rings, install the black snap rings.
4. Check the U-joints for freedom of movement.
-
If binding, strike the yoke with a brass or plastic hammer.
NOTE: Do not strike the bearings.
5. Install the driveshaft.
