Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
8. Remove the EPC and SSB/SS2 solenoids.
1. Remove the solenoid clamp screws.
2. Remove the solenoid clamp.
3. Remove the EPC and SSB/SS2 solenoids.
CAUTION:
-
The TCC solenoid and converter modulator valve may pop out of its bore. This may damage the solenoid or converter modulator valve.
-
Shift solenoids may pop out of their bore. This may damage the solenoids.
9. Disconnect the Turbine Shaft Speed (TSS) sensor electrical connector from the transmission case (16 pin) electrical connector.
1. Disconnect the TSS sensor electrical connector.
2. Remove from the TSS sensor wire locator.
CAUTION: Do not pry on the other wires or damage the connector case surface.
10. Remove the transmission case (16 pin) electrical connector retaining spring.
CAUTION: Do not overstretch the retaining spring.
