Ranger 2WD L4-2.3L (2009)
Satellite Digital Audio Receiver System (SDARS) Module
Removal and Installation
1. NOTE: Module configuration is required when a new Satellite Digital Audio Receiver System (SDARS) module is being installed.
Upload the SDARS module configuration information to the scan tool. For additional information, refer to
Programmable Module Installation (PMI) in Information Bus.
2. Lower the glove compartment completely.
3. Disconnect the satellite antenna cable and the SDARS module electrical connector.
4. Remove the 3 nuts.
-
To install, tighten to 8 Nm (71 lb-in).
5. Remove the 3 J-studs and the SDARS module.
6. To install, reverse the removal procedure.
-
Download the SDARS module configuration information to the scan tool.
