Ranger 2WD (2009) Arm Rest Service and Repair
6. Fasten the J-clips and fasten the underside hook-and-loop strip.
7. Install the pin-type retainer and fasten the rear hook-and-loop strip.
8. Install the safety belt buckle pretensioner and install the nut.
-
Tighten to 40 Nm (30 lb-ft).
9. Route the wiring harness to the cushion.
-
Route the wiring harness.
-
Fasten the wiring harness and electrical connector pin-type retainers.
-
Connect the seat position sensor electrical connector.
10. Install the 2 cup holder mounting screws and attach the cup holder.
-
Tighten to 7 Nm (62 lb-in).
11. Install the 60 percent bench seat. For additional information, refer to Seat - Front See: Seats/Service and Repair/Front Seats/Seat - Front.
