Ranger 2WD L4-2.3L (2009)
2. Detach the coolant bypass hose from the routing clip.
3. Disconnect the coolant bypass hose from the coolant bypass tube.
Vehicles equipped with a manual transmission
4. Remove the shifter.
All vehicles
5. Remove the rear driveshaft.
6. Remove the exhaust downpipe.
7. NOTE: Manual transmission shown, automatic transmission similar.
Support transmission with an appropriate transmission jack.
8. Remove the 6 crossmember-to-frame bolts (3 on each side).
-
To install, tighten to 99 Nm (73 lb-ft).
9. Detach the transmission electrical connector and wiring harness retainers from the crossmember. Remove the transmission mount nuts and the
crossmember.
-
To install, tighten to 99 Nm (73 lb-ft).
10. Lower the transmission to access coolant bypass hose.
11. Disconnect the coolant bypass hose from the rear coolant outlet pipe and remove the coolant bypass hose.
12. To install, reverse the removal procedure.
