Ranger 2WD L4-2.3L (2009)
1. NOTE: Check that there is no dirt or particles within the valve stem grooves. Check the seating of the valve collets.
NOTE: Check the seating of the valve spring retainer keys.
Using the 3 Valve Spring Compressors, install the valve springs.
-
Insert the valve springs and the valve spring retainers.
-
Using the 3 Valve Spring Compressors, compress the valve spring and install the valve spring retainer keys using some grease and a small
screwdriver.
2. Disconnect the compressed air supply and install the spark plug.
-
Tighten to 15 Nm (133 lb-in).
3. Repeat the appropriate removal and installation steps for each of the cylinders being serviced.
4. Install the valve tappets. For additional information, refer to Valve Tappets See: Camshaft, Lifters and Push Rods/Lifter / Lash Adjuster/Service
and Repair/Removal and Replacement/Valve Tappets.
