Ranger 2WD L4-2.3L (2009)
Headlamp Bulb: Service and Repair
Headlamp Bulb
Removal and Installation
WARNING: The bulb contains gas under pressure. The bulb may shatter if the glass envelope is scratched or if the bulb is dropped. Handle the
bulb only by its base. Avoid touching the glass envelope. Failure to follow these instructions may result in personal injury.
NOTE: The headlamp bulb should not be removed from the headlamp until just before a replacement bulb is installed. Removing the bulb for an
extended period of time may affect headlamp bulb performance. Contaminants may enter the headlamp assembly where they can settle on the lens and
reflector. Never turn the headlamps on with the bulb removed.
1. Remove the headlamp assembly. For additional information, refer to Headlamp Assembly See: Service and Repair.
2. Rotate the headlamp bulb retainer approximately one-eighth turn counterclockwise and remove it.
-
Remove the headlamp bulb.
3. To install, reverse the removal procedure.