Ranger 2WD L4-2.3L (2009)
Ignition Coil: Service and Repair
Ignition Coil Pack
Ignition Coil Pack
Removal and Installation
1. Disconnect the ignition coil electrical connector.
2. NOTICE: It is important to twist the spark plug wire boots while pulling upward, to avoid possible damage to the spark plug wire.
NOTICE: Spark plug wires must be connected to the correct ignition coil terminal. For additional information, refer to the Coil
Terminal-to-Cylinder Relationship illustration in the Description and Operation, Engine Ignition See: Description and Operation.
Failure to follow this instruction may result in poor engine performance.
Squeeze the locking tabs and twist while pulling upward, to disconnect the 6 spark plug wires from the ignition coil.
3. Remove the 4 bolts and the ignition coil.
-
To install, tighten to 6 Nm (53 lb-in).
4. NOTE: Apply silicone dielectric compound to the inside of the spark plug wire coil boots.
NOTE: Be sure to reinstall the radio ignition interference capacitor under the correct ignition coil mounting bolt.
To install, reverse the removal procedure.
