Workshop Repair Manuals

Ford Workshop Manuals

[NEXT PAGE]

ford Workshop Repair Guides


Ranger 2WD L4-2.3L (2009)

Relays and Modules > Relays and Modules - Accessories and Optional Equipment > Communications Control Module > Component Information > Service and Repair > Audio Unit Shipment Mode

Page 1
background image

Communications Control Module: Service and Repair
Audio Unit Shipment Mode

Audio Unit Shipment Mode

Entering Shipment Mode

CAUTION: The CD6 audio unit must be placed in shipment mode anytime the audio unit is removed (including for diagnostic purposes).
Failure to follow this instruction may result in damage to the audio unit.

NOTE: This procedure applies to the CD6 audio unit.

1. Turn the audio unit on and eject any CD's loaded in the audio unit.

2. Turn the key to OFF.

3. Press and hold presets 2 and 5, simultaneously.

4. While holding the presets, turn the key to ACC or RUN.

-

The audio display will flash SHIPMENT.

-

When the CD tray has parked, the audio unit will display SHIPMENT ON.

5. Turn the key to OFF.

6. Remove the audio unit. For additional information, refer to Audio Unit  See: Accessories and Optional Equipment/Radio, Stereo, and Compact

Disc/Radio/Stereo/Service and Repair/Removal and Replacement/Audio Unit.

Exiting Shipment Mode

NOTE: If the audio unit is removed, install the audio unit before beginning this procedure.

1. Turn the key to ACC or RUN.

2. Turn the audio unit on.

3. Press and hold the LOAD button for approximately 2 seconds.

-

The audio unit will enter loading mode, at which time the shipment mode will be exited.

4. Turn the audio unit off.

Relays and Modules > Relays and Modules - Accessories and Optional Equipment > Communications Control Module > Component Information > Service and Repair > Audio Unit Shipment Mode

[NEXT PAGE]