Ranger 2WD L4-2.3L (2009)
Removal
1. Remove the axle shaft. For additional information, refer to Axle Shaft See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle
Shaft Assembly/Service and Repair/Removal and Replacement/Rear Drive Axle/Differential - Ford 8.8-Inch Ring Gear.
2. NOTE: If only a new seal needs to be installed, use care to avoid damaging the seal bore.
Using a suitable seal remover, remove and discard the axle shaft oil seal.
3. Inspect the rear wheel bearing and axle shaft for wear or damage.
4. If necessary, using the Axle Bearing Remover and Impact Slide Hammer, remove the rear wheel bearing.
Installation
1. Lubricate the new rear wheel bearing with rear axle lubricant.
2. Using the Axle Shaft Bearing Installer and Adapter, install the rear wheel bearing.
3. Lubricate the lip of the new wheel bearing oil seal with grease.
4. Using the Rear Axle Oil Seal Installer and Adapter, install the wheel bearing oil seal.