Ranger 2WD L4-2.3L (2009)
3. Drain transmission fluid.
-
Remove all the transmission fluid pan screws except for 2 in the front. Loosen the 2 front transmission fluid pan screws. Pry the rear of the
transmission fluid pan down and allow fluid to drain. After fluid is drained, remove the front 2 transmission fluid pan screws.
4. NOTE: The transmission fluid pan gasket is reusable. Clean and inspect for damage, if not damaged, the gasket should be reused.
Remove the transmission fluid pan.
1. Remove the transmission fluid pan.
2. Remove the transmission fluid pan gasket.
5. Remove and discard the transmission fluid filter.
1. Remove the transmission fluid filter screw.
2. Remove the transmission fluid filter.
6. Unclip main control valve body wire harness.
-
Lift up on wire harness guide and protector and disengage the retaining pins from the solenoid clamps.
7. Disconnect the 6 solenoid electrical connectors.