Ranger 2WD L4-2.3L (2009)
6. NOTE: The main control valve body screws will be tightened in later steps.
Loosely install the M6 x 30 mm (1.181 in) screw.
7. NOTE: The main control valve body screws will be tightened in later steps.
Loosely install the 16 M6 x 40 mm (1.574 in) main control valve body screws.
8. Tighten the main control valve body screws in the sequence shown.
-
Tighten to 10 Nm (89 lb-in).
9. Rotate the manual lever into the NEUTRAL position.
10. Install the manual control valve detent lever spring.
1. Position the manual control valve detent lever spring.
2. Install the manual control valve detent lever spring screw.
-
Tighten to 10 Nm (89 lb-in).
11. Install the low/reverse band servo piston and rod.
