Ranger 2WD L4-2.3L (2009)
3. Using the Keystone Clamp Installer, crimp the driveshaft slip-yoke boot clamp.
4. Install the driveshaft slip-yoke on the driveshaft.
1. Pull the slip-yoke boot toward the driveshaft. Lubricate the driveshaft splines with approximately 10 g (0.24 oz) of lubricant.
-
Use grease as the lubricant.
2. Position the new large slip-yoke boot clamp.
3. Align the index marks and install the driveshaft slip-yoke on the driveshaft.
5. Set the driveshaft assembled length to specification.
1. Remove any excess grease from the slip-yoke boot and driveshaft slip-yoke surfaces.
2. Position the slip-yoke boot in the slip-yoke boot groove.
3. Set the driveshaft assembled length to specification.
-
Measure from the stub shaft weld to the end of the driveshaft slip-yoke.
4. Bleed the air from the slip-yoke boot.
6. Using the Keystone Clamp Installer, crimp the large driveshaft slip-yoke boot clamp.
