Ranger 2WD L4-2.3L (2009)
7. NOTE: Do not damage the wheel bearing oil seal.
Remove the 2 axle shafts.
Installation
1. Lubricate the lip of the wheel bearing oil seal with grease.
2. NOTE: Do not damage the wheel bearing oil seal.
Install the 2 axle shafts.
3. NOTE: Do not damage the rubber O-rings in the U-washer grooves.
Position the 2 U-washers on the button end of the axle shafts and pull the axle shafts outward.
4. Install the differential thrust plate.
1. Align the hole in the thrust plate shaft with the case lock bolt hole.
2. Install a new differential pinion shaft lock bolt.
5. Install the rear brake drums.
