Ranger 2WD L4-2.3L (2009)
Windshield Washer Reservoir: Service and Repair
Washer Pump and Reservoir - 2.3L
Removal and Installation
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result
in serious personal injury.
NOTE: To prevent spilling windshield washer fluid, drain the windshield washer reservoir before removal.
1. Disconnect the windshield washer reservoir pump electrical connector.
2. Disconnect the wiring harness retainer.
3. Remove the Air Cleaner (ACL) assembly.
4. NOTE: The windshield washer reservoir and the washer pump are serviced independently.
Remove the 2 reservoir bolts and 2 reservoir nuts.
-
To install, tighten to 6 Nm (53 lb-in).
5. Remove the windshield washer reservoir-to-coolant reservoir stud.
6. Position the coolant reservoir aside.
7. Remove the windshield washer reservoir.
8. Disconnect the windshield washer hose from the windshield washer pump.
9. NOTE: When removing the washer pump from the washer reservoir, be sure not to damage the rubber grommet.
Remove the washer pump from the washer reservoir.
10. To install, reverse the removal procedure.
