Ranger 2WD L4-2.3L (2009)
Wiper Arm: Service and Repair
Wiper Mounting Arm and Pivot Shaft
Wiper Mounting Arm and Pivot Shaft
Removal and Installation
1. Cycle the windshield wiper blades until they are in the straight UP position.
2. Remove the RH and LH windshield wiper pivot arms.
1. Pull up on the pivot arm.
2. Pull out on the retainer tab.
3. Position the PCM connector and harness aside.
1. Loosen the bolt.
2. Remove the nut and stud.
-
Disconnect the PCM electrical connector and position the harness aside.
4. Remove the RH access cover.
1. Remove the screws.
2. Remove the access cover.
5. Position the Power Distribution Box (PDB) aside and remove the LH access cover.
