Ranger 2WD L4-2.3L VIN D (2001)
5. Install the short brake shoe retracting spring.
1
Place the brake shoe adjusting lever cable over the anchor pin, with crimped side in.
2
Install the short brake shoe retracting spring.
6. NOTE: Make sure the brake shoe adjusting lever cable is positioned in the cable guide groove.
Install the long brake shoe retracting spring.
1
Install the cable guide.
2
Position the brake shoe adjusting lever cable in the cable guide groove.
3
Install the long brake shoe retracting spring.
7. Disassemble the brake adjuster screw assembly and apply Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A (Motorcraft
WA-10) or an equivalent silicone compound meeting Ford specification ESE-M1C171-A.
8. Assemble the brake adjuster screw assembly.
9. NOTE: To prevent incorrect installation, the socket end of each brake adjuster screw is stamped R or L.
Install the brake adjuster screw assembly.
1
Position the brake adjuster screw assembly.
2
Install the brake shoe adjusting screw spring.